IMC Networks IE-MiniMc Instruction Manual download pdf (Page 7)

DC Terminal Block Wiring Instructions

The IE-MiniMc LFPT and Telco/LFPT can also be powered with the DC terminal

block. From a power source, connect to any one positive and any one negative

terminal on the IE-MiniMc LFPT and Telco/LFPT. Shown below are the IE-MiniMc

LFPT (left) and IE-MiniMc Telco/LFPT (right).

+5to24VDC

+12to48VDC

Non-Telco Power Telco Power

NOTE

When using stranded wire, the leads must be tinned. The DC terminal block is

protected against mis-wiring; if mis-wired, the chassis will not function. The chassis

is internally connected to the negative power terminal.

Cascading DC Power

When installing multiple IE-MiniMc LFPT and Telco/LFPT units on a DIN rail, the end

user can connect to one DC input source, and then cascade from one DC block to

the next, until reaching the maximum current available.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

IMC Networks IE-MiniMc Instruction Manual Page 7